The Hillman Minx was a mid-sized family car that British car maker Hillman produced from 1931 to 1970. There were many versions of the Minx over that period, as well as badge-engineered variants sold by Humber, Singer, and Sunbeam.
From the mid-1950s to the mid-1960s, the Minx and its derivatives were the greatest-volume sellers of the "Audax" family of cars from Rootes, which also included the Singer Gazelle and Sunbeam Rapier. The final version of the Minx was the "New Minx" launched in 1967, which was part of the "Arrow" family and essentially a basic version of the Hillman Hunter. Generally, the Minx was available in four-door saloon and estate forms, with a 1496-cc engine.
The Hillman Super Minx was a slightly larger model offered during the Audax era.
Throughout the life of the Minx, there was usually an estate version—and, from 1954 to 1965, a short-wheelbase estate, the Hillman Husky, and a van derivative known as the Commer Cob.
The Minx model name was revived briefly – along with the "Rapier" name, as applied to the Sunbeam Rapier version of the Audax family – as a special edition late in the life of the Talbot Alpine / Talbot Solara cars, produced by Chrysler Europe after its takeover of the Rootes Group.
The original Minx was announced to the forewarned (in August) public 1 October 1931. It was straightforward and conventional with a pressed-steel body on separate chassis and 30 bhp 1185 cc engine producing cushioned power.[note 1] It was upgraded with a four-speed transmission in 1934 and a styling upgrade, most noticeably a slightly V-shaped grille. For 1935 the range was similar except that synchromesh was added to all forward gears and this Minx became the first mass-produced car with an all synchromesh gearbox. it was designed by Rootes' technical director Captain John Samuel Irving (1880-1953) designer of Sunbeam aero engines and Sunbeam's Golden Arrow in conjunction with Alfred Herbert Wilde, (1891-1930) recently chief engineer of Standard and designer of the Standard Nine.
The 1936 model had a new name, the Minx Magnificent, and a restyle with a much more rounded body. The chassis was stiffened and the engine moved forwards to give more passenger room. The rear panel, previously vertical, was now set at a sloping angle, and the manufacturers offered the option of a folding luggage grid attached to the rear panel for "two pounds, seven shillings and sixpence" (slightly under £2.40) painted. A Commer-badged estate car was added to the range.
The final pre-war model was the 1938 Minx. There were no more factory-built tourers but some were made by Carbodies. The car was visually similar to the Magnificent, with a different grille, and access to the luggage boot (trunk) was external (that on the predecessor was accessed by folding down the rear seat). There were two saloon models in the range, the basic "Safety" model with simple rexine trim instead of leather, no opening front quarterlights, and less luxurious trim levels. The De Luxe model had leather trim, opening quarterlights, extra trim pads, and various other comfort benefits. The 1938 model was not the final iteration before the outbreak of war, however, as the 1939 model was considerably different mechanically, with virtually the entire drivetrain improved to the extent that few parts are interchangeable with the 1938 model. This includes gearbox, differential, half shafts, steering box, and a great many other mechanical and cosmetic changes. Even the front grille, which to the casual eye looks almost identical to the 1938 model, became a pressed alloy component rather than a composite.
During the Second World War, British car companies produced simple Utility load carriers, the Car, Light Utility or "Tilly" which was later developed into the experimental Hillman Gnat. For Hillman it was the Hillman 10HP, a Minx chassis with two-person cab and covered load area behind. The basic saloon was also produced for military and essential civilian use from 1940 to 1944.
The Minx sold between 1945 and 1947 had the same 1185 cc side-valve engine, the same wheelbase and virtually the same shape as the prewar Minx. This postwar Minx became known as the Minx Mark I (or Minx Phase I). This was the first Minx with a protruding boot (trunk) that nodded to the Ponton, three-box design by then replacing the 'flat back' look, inherited from models that had debuted in the 1930s. Between 1947 and 1948, Hillman offered a modified version they called the Minx Mark II.
A much more modern looking Minx, the Mark III, was sold from 1948. Three different body styles were offered initially, these being saloon, estate car and drophead coupé (convertible). Beneath the metal, however, and apart from updated front suspension, little had changed: the Mark III retained the 1185 cc side-valve engine of its predecessor. Claimed power output, at 35 bhp (26.1 kW), was also unchanged. However, in 1949 the old engine was bored out and compression ratio increased, for the Minx Mark IV, to 1265 cc, and power output increased by 7 per cent to 37.5 bhp (28.0 kW). A Mark IV saloon tested by The Motor magazine in 1949 had a top speed of 67 mph (108 km/h) and could accelerate from 0–60 mph (97 km/h) in 39.7 seconds. A fuel consumption of 32.1 miles per imperial gallon (8.8 L/100 km; 26.7 mpg‑US) was recorded. The test car cost £505 including taxes, the price including radio (£36), over-riders (£5) and heater (£18).
The Mark V, introduced in 1951, featured side chromium trim and a floor mounted handbrake.
The Mark VI of 1953 featured a new grille, revised combustion chambers and a two-spoke steering wheel. A fourth body variation was added, badged as the Hillman Minx Californian, a two-door hard-top coupé with, slightly unusually, a b-pillar that wound down out of sight along with the rear side window to give an unbroken window line when all windows were fully opened: the rear window assembly was of a three-piece wrap-around form. The wheelbase and overall length of the car remained the same as those of the four-door saloon and convertible permutations. The Mark VII, also introduced in 1953, featured longer rear mudguards and a bigger boot. For the Mark VIII, in 1954, a new ohv 1390 cc engine was installed. This engine, two years later, went into the first of the new "Audax series" Minxes.
For a short time in the early 1950s, Hillman Minxes were sold in the US to Americans seeking better gas mileage. American reviews of the vehicle were lukewarm. Between 1953 and 1956 the Mark VI to Mark VIII Isuzu Hillman Minx was produced in Japan by Isuzu Motors, prior to their 1961 introduction of the Bellel.
A 2-door coupé utility variant of the Minx Mark VIII was produced by Rootes Australia as the Hillman de luxe Utility, circa 1956.
The Audax body was designed by the Rootes Group, but helped by the Raymond Loewy design organisation, who were involved in the design of Studebaker coupés in 1953. Announced in May 1956 the car went through a succession of annual face lifts each given a series number, replacing the mark number used on the previous Minxes. The Series I, introduced in 1956, was followed by the Series II in 1957, the Series III in 1958, the Series IIIA in 1959, the Series IIIB in 1960, the Series IIIC in 1961, the Series V in 1963 and the Series VI in 1965. There was no Series IV. Over the years the engine was increased in capacity from 1390 cc (in the Series I and II) to 1725 cc in the Series VI. A variety of manual transmissions, with column or floor change, and automatic transmissions were offered. For the automatic version, the Series I and Series II used a Lockheed Manumatic two pedal system (really only a semi-automatic), the Series III a Smiths Easidrive and the V/VI a Borg Warner. The Series VI was fitted with an all-synchromesh gearbox.
A Series III deLuxe saloon with 1494 cc engine tested by the British magazine The Motor in 1958 had a top speed of 76.9 mph (123.8 km/h) and could accelerate from 0–60 mph (97 km/h) in 25.4 seconds. A fuel consumption of 31.8 miles per imperial gallon (8.9 L/100 km; 26.5 mpg‑US) was recorded. The test car cost £794 including taxes of £265.
There were Singer Gazelle and Sunbeam Rapier variants of all these Hillman Minx models, and the names were again used on derivatives in the later Rootes Arrow range. Some models were re-badged in certain markets, with the Sunbeam and Humber marques used for some exports.
The New Zealand importer/assembler Todd Motors created the Humber 80 and Humber 90, badge-engineered models based respectively on the Minx and Super Minx, as a way to secure scarce additional import licences for CKD assembly kits. Although the 90 was identical to the Super Minx, the cheaper 80 featured a horizontal bar grille design. The Humber 80 was acknowledged in the 1980s Roger Hall play Prisoners of Mother England, in which a newly arrived immigrant in New Zealand spots one and exclaims: "Humber 80? There's no such car!"
Complete article available at this page.
This post have 0 komentar
EmoticonEmoticon