The BSA Ten is a small car manufactured for BSA Cars by BSA subsidiary The Daimler Company Limited.Announced in October 1932 first deliveries were delayed until February 1933.A cheaper and less well-finished version of the Lanchester Ten with a smaller side-valve engine of BSA design. An offering to try to meet the market of the Great Depression.
Additional details to those in the tables
One-piece pressed-steel body with sliding roof and leather upholstery, Triplex safety glass.
The crankshaft runs in two large bearings. Timing is by chain. The valves are at the side and worked by tappets acting directly on a large-diameter two-bearing camshaft. Tappets are on the near side and may be accessed for regulation. Sparking plugs are easily accessed. The vertically driven make and break and distributor is on the off side in front of the generator. Inlet and exhaust manifolds are cast together and mounted on the near side. There is an air cleaner. Petrol is delivered by pump. The electrical system is 12 volt.
Daimler fluid flywheel and Wilson four-speed preselective self-changing gearbox.The propeller shaft is open and has mechanical joints. The banjo back axle case contains spiral bevel gearing.
The frame has the popular cruciform or X channelled sectioned cross membering.The unit of engine, fluid flywheel and self changing gearbox is held at four points on rubber, the two points in front being close together and on the cross member. Half elliptical springs wide-set to prevent roll are fitted with hydraulic shock absorbers. Steering is by cam and lever. The four-wheel brakes are worked by rods.
The motoring correspondent of The Times reported reaching 57 mph (92 km/h) under favourable conditions, the makers' estimate of fuel consumption was 35 mpg at 30 mph.
New bodies for 1934 were:
Complete article available at this page.
This post have 0 komentar
EmoticonEmoticon